Dongle-Duplicate

dongle@nsys.by


Before we can read a Hasp - we need to know  our Hasp passwords. They are diferent for each software vendor. 
If you don't know them or don't know what they are - read how to get Hasp Passwords 
If you know them - continue to reading sep by step procedure below.  

1.

Now we have our hasp passwords ready and your hasp plugged.

Note that from this point everything can be done on any PC. 
It is not need to have your protected application installed.

Download Hasp reader archive:  HaspHLrdr.zip (100kb)

2.

Create separate folder for it.  For example C:\HaspHLrdr 

3.

Unzip downloaded archive in to this new folder. It is 3 files: 

HaspHLrdr.exe,
Dongdupe.sys,
Dongdupe.inf

4.

First of all we need to install reader drivers. This is a standard OS procedure as for any other hardware but for clarity it is illustrated below.  Note that later driver can be removed in same way.

5.

Go to "Start"  =>  "Settings" => "Control Panel" => "System"

6.

Select "Hardware" tab => "Device Manager" and then in USB Devices tree find our USB device. In most cases it will be "Aladdin USB Key".  Now RIGHT CLICK mouse on it and select "Update Driver..."
P.s Device Manager can also be reached in other ways. 





7.

Hardware Update Wizard will start.  When offered - select "No, not this time" and go "Next".





8.

Select "Install from a list or specific location" and go "Next"





9.

On the search and install options select "Don't search. I will choose the driver to install" and go "Next"





10.

Then offered to select driver to install. It could be seen a number of items on the list - just ignore them and press "Have Disk..."  





11.

Opens Install from Disk dialog - press "Browse..." and locate dongledupe.inf file which is in the same folder where we unzipped whole reader - see step_3 above.  In our example it is C:\HaspHLrdr .   Select it, then "Open" and "OK".





12.

Later you can see a warning that Dongle-Duplicate driver is not passed Windows Logo. Select "Continue Anyway"








13.

At the end is final screen saying that installation done. Select "Finish".

Here we MUST  Restart PC.  In most cases it will be the ask to do so from Windows, but if not - we sill need to reboot now.





14.

After restart we can go to Device Manager again and verify if our driver is loaded ok - see steps 5. and 6. above. On the list we should see "Dongle-Duplicate reading driver".  Note that hasp has to be plugged all this time.





15. 

Now we a fully ready to read. Go to the folder where reader is - in our example it is C:\HaspHLrdr 
Run HaspHLrdr.exe  enter your hasp passwords (in our example they was 3C39:25A0) and press "Read".
Wait few minutes until it tells that reading done and data in to file saved. This data file with DMP extension saved in same to same folder where reader is. Find it and email to dongle@nsys.by 










